Questions & Answers for: projector screen goes black hours

...screen goes black and stays that way for 1 or 2 minutes. Then, the screen gets bright and all is well for as long as the TV stays on. If we power down for an hour or so, It will do it all again. This ...

...screen. I can shut it down, wait a couple minutes and the result is the same thing, after a minute the picture just goes black. This seems to be a heat related issue. There are two fans internally, ...

...screen had green lines going horizontal then just went black. sound is there, red light came on. had technician come out and he seem confused. he said the lamp comes on then shuts off. he said it ...

...screen. light is blinking green, then solid green, then after some time goes red? We have a PT-50LC14. We replaced the lamp 6 months ago with a TY-LA1000 bulb we bought from a company online (not ...

screen goes to this dusky blue color. The blue haze is always there, unless the projector is off. I've changed the bulb, and air filter with factory parts, and have had no success. ANy advice? On the

projector has been used regularly, handled with care and cleaned from dust inside (metal filter). Now this past month it has developed this fault: 20 to 30 minutes after switched on the lamp goes out

...projector HLR4667w when lturn the tv on normal picture after few minute both side of the screen go black and a green screen with lines oppose to see the picture well CK for bad capacitors on power ...

screen (only takes a few seconds to go through all these states before returning to normal just briefly and then starting all over again). I've used a projector which worked fine so I'm pretty sure it

...screen goes black. I put a new bulb in about four months ago. The bulb has about 200 hrs of use. Reset the lamp hours as follows. Press the Exit button on the projector for 3 seconds to display the ...

...screen is black also. the model is a wd 57732 mitsubishi. i just replaced the lamp. still no picture Might be the connector of your lamp is losing. Need to reset the program of the unit if your reach ...