Questions & Answers for: program door lock camry

...steps when you installed your new receiver.This car (2000 Camry) is not programed to give anyone a problem when battery is disconnected. You may have discon the module for the door locks and

...door lock and unlock issues I bought a 1999 Toyota Camry V6 3.0L automatic. It driven by a old woman and has only 43K miles on it. The problem I have is that when I insert the key to drvier side ...

...door locks will cycle confirming program.continue to do other remotes you have,steps 8 and 9.if only one in possesion,you are done. to end mode open door or insert key into ig.you can do up to 4 ...

...PROGRAM 2003 TOYOTA CAMRY FACTORY REMOTES 1. Driver door open and unlocked. Key out of the ignition 2. Insert the key and remove 2 times in 5 sec. 3. Close and open driver door 2 times in 40 sec. 4. ...

...door You don't program the key you program the computer, however if you have the original key you can remove the antenna out of the key and make a new key and fit the antenna into the new key, the ...

...program the door locks on my 2002 Camry so they do not lock when you put the car in gear? Put the key in the ignition, turn to the on position. Open the driver's door and remove the key (keep door ...

...Program Wireless Remote Transmitters: Begin with: The driver's door open and unlocked. Key out of the ignition. 1.Insert and remove the key from the ignition switch 2 times within 5 seconds. Steps 2 ...

...program remaining remote transmitters.note to exit programming mode close drivers door or insert ignition key.maximum of 4 remote transmitters can be programmed.if akk failed let dealership reprogram ...

...door lock actuators, faulty ECU.-------The problem can be out of this.But you cannot directly pin point that any of the one is faulty, it can be any of the one out of this.---------- Click this link ...

...door lock remote is not working? Im not sure that I understand your question and dont want to give the wrong answer. There are no "codes" persay for anything but radios as far as end user procedures ...