Questions & Answers for: problems caused engin oil fill

Question about 2006 Grand Vitara

1 Answer

...point on dipstick start car check oil filter for leaks turn car off let oil settle and check level again too much oil in a motor will cause problems so dont over fill hope this helps

Ad

Question about Bilt Tb425cs 26cc 4 - Cycle Curved - Shaft Gas Trimmer with Ez - Start and Speed Spool

3 Answers

...oil fill plug on the back of the machine where motor oil goes when trimmer is level the and the oil fill plug is removed the level should be at the top of the bottom of the threads or let it run out ...

Ad

Question about Bilt Tb425cs 26cc 4 - Cycle Curved - Shaft Gas Trimmer with Ez - Start and Speed Spool

1 Answer

...with the engine oil. Head gasket leak and can cause overheating A clogged up heater core or radiator can cause overheating A loose or worn seal on the radiator fill cap can cause overheating as ...

Question about Bilt Tb425cs 26cc 4 - Cycle Curved - Shaft Gas Trimmer with Ez - Start and Speed Spool

1 Answer

...you fill the crankcase FULL...IF YOU filled it... it is over pressurizing and burning the oil..this will continue until its burns off the excess or you change the oil and put in the correct

...oil in overheating conditions. Also inspect the water pump to ensure it is being driven by the belt. You may also have air in the cooling system that is causing all your problems. Generally only ...

put it in If your float stuck in your carb the engine could fill with gas causing the oil to overflow and the engine to smoke.Try changing your oil.If it comes out smelling like gas thats your problem

I have a 1983 yamaha seca 400 and when I turn in on all of this oil start coming out of the air filter can anyone tell me what could be causing this problem Blown piston rings Remove the seat and open

What causes loss of engine idling on Mitsubishi colt fitted with a 4m40 turbo charged engine? The problem started after the engine oil leaked through the oil filter and the engine cut on its own. ...

...caused the carburetor to gum up. Also Honda engines have a low oil sensor and from your description of the oil, can cause problems with the sensor and the engine won't start. Try changing the oil ...

...from oil pump pickup point in the sump same with fuel fuel ....pump only on one side of the tank .. check oil density,viscosity....check oil level or fill d oil...clean d engine and fill the new ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Top Cars & Trucks Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

john h

Level 3 Expert

29494 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Are you a Cars & Trucks Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...