Question about PL926WBi 19" LCD Monitor
printing, came back 4 hours later and found my Proview monitor black. I moved my mouse and nothing happened. I tried control, alt and delete, nothing changed. I turned off my computer and back on, the
monitor displays a short signal then goes black. Now...get this. I use a hair dryer to warm up the back of the monitor just above the power button and within a few minutes the screen is fine? Is there
Question about FPD 1750 17" Flat Panel LCD Monitor
...monitor goes black until it cools down and makes contact again. You could resolder it if you knew where it was but monitors are dangerous to go playing around with as they can hold very high charges ...
Question about E152FPb 15" TFT LCD Flat Panel Monitor
...goes black. Please help! Thanks...Dan dhowie, Monitor will need work done to internal "switch-mode-power-supply"/"CCFL inverter supply board. possible bad electrolytic filter capacitors or thermally ...
...monitor hpL1908w goes off after a few minutes when am in the middle of a task. how do i solve this? suzan jamaa195, Suzan, You may want to visit this link to find out what might be L1908 problem of ...
...goes black!! when i turn it off and back on it stays on for a few min. agin!! nogooddeed, Yes, You too, will need to visit this blog that is quite old, but still of some importance!!! ...
...monitor cutting off, goes black dell E228WFP monitor cutting off. has great picture when active. only keeps screen up for 3 seconds and goes black. like a relay is dropping. sysjrm, You need to visit ...
...goes black. The monitor is still getting a signal from the computer as indicated by a solid blue power light. turning off the monitor and back on does nothing other than getting a gateway logo, then ...
...monitor. It rolls, the color is bad, sometimes I cannot recognize print, it becomes blurred. It goes black screen, it goes red screen, blue screen dear\..... you are use bad type data cable bay ...
goes back to black screen there are many reason why a monitor suddenly turned off then back to work again , over use may over heat that cause the soled parts on the printed board of your CRT go loosen
Usually answered in minutes!
19,138 Questions
12,216 Questions
7,310 Questions
7,277 Questions
5,472 Questions