Questions & Answers for: printer dent paper

...there is a dent then that's probably the problem.look where dent is on paper and that is where you should look for the piece that's causing the jam,if that does'nt solve problem i would need more ...

...dent in the paper same direction as paper travel. to remove the fuser you will need a small offset phillips #2 screwdriver and some patience. 1. pull platen to left to acess upper cover screw, remove ...

...dent in paper I am having a problem with a small dent appearing about half way across the page and it repeats about every 4.5 inches vertically down the page. The dent is small, about 1/8 inch ...

...dent in the leading edge of the paper about one inch from the right when viewed from the front Hello there You may not see a paper jam. This may work for you, it has worked for many here I given this ...

printer (or a paperclip or staple!) Use the owner's manual to inspect the paper jam areas. look inside the area that the developer cartridge goes and see if there is anything in the paper slot. When a

...or a pen ? Is there an access door on the rear of the printer. If so, open up and check to see if the jammed paper is hitting something or has a "dent" in it where it's hitting the object. Good luck

paper there is a dent on the leading edge which seems to indicate an obstruction about 60mm from left hand side stopping left hand side of paper feeding in. the feeder wheel is fine, what do you think

...My SCX-3405W consistently makes two creases at the bottom of the paper, each crease has four circular dents in it. Is there any way to fix this? I have the same problem with my

...Printer dents paper. You will want to call a tech or contact Brother if under warranty to replace the fuser assembly. We had this problem in the duplexer built into the fuser assembly, we also had to ...

Printed pages are dented as if embossed at regular intervals. The dents are consistent as to shape and location. Printing appears in the shapes as required. Printed paper is dented This is caused by ...