i have a poulan 2050 chainsaw. hookup primer my primer is not hooked up. one line runs from tank to carb. should line run from tank to primer, then to carb? is the primer necessary? hi, Yes it is and ...
The primer is split.. Have new bulb but cannout figure out how to install...The hoses were also rotton. Normally there is a couple of screws beside the primer bulb. Remove screws, remove primer plate.
fuel lines from primer bulb the fuel lines rotted off. The primer bulb seems OK. Which lint goes to the crab and which goes to th fuel tank, the long one in the center and the short one to the side. ...
Question about Pro 42CC 2 Cycle Chainsaw, 18"
i am replacing a primer bulb in a chainsaw and the lines are gone so i need to find out which line goes where Leave both primer ports open, then attach the fuel line that feeds the carburetor from the
Question about Pro 42CC 2 Cycle Chainsaw, 18"
...Ryobi 410r tiller/cultivator needed new fuel line so I bought the fuel line, return and a new bulb primer. Unfortunately, I can't remember what hose goes where!!! Specifically, I've hooked ...
Question about Pro 42CC 2 Cycle Chainsaw, 18"
How do you replace primer bulb on model 917.385125 B&S 550 series motor on a Craftsman mower? There doesn't seem to be a way to release the old primer bulb. Hate to replace carburetor just because
Question about Pro 42CC 2 Cycle Chainsaw, 18"
Replaced fuel lines and primer bulb ON A BOLENS LB 160 25 cc TRIMMER. Primer bulb stays in and wont pop out. it pops out after abouot 3 minutes or if I loosen the primer bulb mounting screws Check the
How to replace primer bulb Shauna, Primer bulb replacement. Check the attached links,instruction and guides, Good luck "I hope this helped you out, if so let me know by pressing the helpful button. ...
Question about Pro 42CC 2 Cycle Chainsaw, 18"
grass trimmer will not prime,cleaned carb.primer will push air in gas tank,but wont pull gas into carb. 25cc craftsman You need to replace the primer bulb. Also check that you have it the right way ...
Question about Pro 42CC 2 Cycle Chainsaw, 18"
I have a husqvarna 440 chainsaw I installed a new carb on it and.now I can't get the primer bulb to prime gas what gives? https://www.partstree.com/models/440-e-husqvarna-chainsaw-2008-05/ The link ...
Usually answered in minutes!
1,998 Questions
1,006 Questions
778 Questions
1,057 Questions
700 Questions