Question about PW2102 Gas Pressure Washer
...pressure in hose and stalls engine Last time I tried to use the washer I had had to keep the trigger pulled on the gun other wise it would build up to much pressure between the pump and the gun and ...
Question about PW2102 Gas Pressure Washer
pressure washer stalls out when wand nozzle is released cannot pull start cord unless wand trigger is depressed. if I release wand trigger while pressure washer is running the engine stalls & shuts ...
...pressure washer had not been used for months. Runs fine but stalls the motor when the trigger is released. Also I need to release pressure to re start. Works only if I hold the trigger continually ...
...STALLS.BACK OFF THE PRESSURE CONTROL(THE VALVE THE PRESSURE HOSE SCREWS ONTO)IT MAY TAKE AFEW TRIES TO GET IT RIGHT,YOU WILL SEE THE NEEDLE ON GAUGE JUMP RIGHT AROUNDJUST AS YOU RELEASE THE ...
...stalls when I release the wand handle (stop water flow from wand). this is because the pressure is wound up too high ,if you back the pressure off abit you will solve the problem. if your machine has ...
Question about PW2102 Gas Pressure Washer
pressure washer will operate at first until I release the trigger on the wand. Then it won't restart. If I wait for a while it will run again. Sounds like the pressure switch. Common with that washer.
...pressure washer and it starts fine and runs for 30 seconds and shuts off. it feels like the motor gets stuck when i try to start it again, but after a half hr or so it will turn over and do the same ...
Question about Gas Pressure Washer 20244
...pressure washer stops running when i pull the trigger check for a blocked main jet in the carby the principle is that when the trigger is released there is no pressure in the pump so the engine is ...
Question about Gas Pressure Washer 20244
...the motor stalls. I can adjust the pressure but when it gets to a higher pressure it stalls the motor replace the pressure regulator as it is not bypassing the water when the trigger is ...
Question about Gas Pressure Washer 20244
...pressure washer 2700psi stalls the motor when I release the trigger. There is pressure coming out of the soap injector tube also. replace the pressure regulator it is not bypassing the water when the ...
Usually answered in minutes!
1,998 Questions
1,006 Questions
778 Questions
1,057 Questions
700 Questions