...pressure switch, heater and module connections poss pressure switch fault Taken from another post......I've got the same problem - happened 5 mins ago so not yet fixed! 'heater relay stuck check ...
...pressure switch pipe(remove it from the pressure switch)it should be clear,you should hear when you open washer door and blow down pipe,bottom of pipe often gets blocked with caked powder,a boil wash ...
Question about Ultima WF860 Front Load Washer
...and clogs up. remove the pipe and clean the filter out and remove gunk from the pressure sensor on the side of the pipe as well. If that does not fix things the pressure switch could be faulty ...
Question about Ultima WF865 Front Load Washer
...F05 - Pressure switch jammed on full - Check pump for blackages. Also resetting the machine sometimes solves the problem switch off at plug for 5 mins then switch back on and try again. hop this ...
...pressure switch activating. The pressure switch itself could be faulty or the hose between the pressure switch and pressure chamber could be broken, causing air to escape and therefore the switch not ...
...pressure switch is jammed and so it does not cut off supply or is cutting off inlet water to the washer. Remove the lines to the pressure switch and reset, check the pressure switch diaphragm Click ...
Question about Ultima WF865 Front Load Washer
...pressure switch located on a hotpoint WMF720 I AM LOOKING TO LOCATE THE POSITION OF THE PRESSURE SWITCH ON A HOTPOINT WASHING MACHINE WMF720 SHOULD BE ON LEFT SIDE OF MACHINE IN THE PANEL ON TOP? ITS ...
Question about Ultima WF865 Front Load Washer
...heater relay. First check that connections on pressure switch are good, Check that heater connections are good.Check the board connections.Check that pump filter is clear. Hope this ...
Question about Ultima WT960P Washer Front Loading, 7 kg., "A" Energy Rating
...pressure switch is stuck and the machine thinks it is full of water. You need to remove the top, look for the pressure switch and unplug the hose on it and blow air through the hose. Then replace the ...
...cycle doesn't move on, have checked hose to pressure switch, not blocked, pressure switch seems ok, any ideas, thanks in advance -Control panel is malfunction. Time for new machine. Good luck ...
Usually answered in minutes!
9,125 Questions
3,839 Questions
3,158 Questions
2,979 Questions
2,660 Questions