Questions & Answers for: pressing wrong keys monitor shuts

...wrong resolution, driver, or refresh rate selected to use when windows boots. Toy around with diffrent resolutions, refresh rates, also if you have a graphics card plug it into that. your on board ...

...wrong? Actually it was quite easy. I rebooted my computer in "safe mode" by restarting it and pressing the F8 key. At the start up windows gives you an option to toggle down to "enable VGA mode" and ...

wrong I had the same problem, some times it worked properly without any problem but sometimes like what robjamsqu said, nothing on screen but other parts worked, but since yesterday it have been still

...wrong with you buttons the procedure is as follows: 1. Turn ignition key to ON (not start) 2. Press ENG MET button on trip monitor & release, then press it again within 5 seconds. 3. Within 5 seconds ...

...monitor into the appropriate laptop connector and use it until you figure out what is wrong with the backlight. I'm doing that myself right now. You must get the CRT/LCD correct to do this. You may ...

...wrong in your hardware settings. If you can, however, that's the OS resolution set too high: the monitor shuts down to protect itself. Boot in safe mode by pressing the F8 key immediately after ...

wrong to my flatscreen since every time I shut down for my PC and turn it on again it shows Auto Config in red letters. I didn't do that before. How do I reset my Acer flatscreen back to normal again?

...WRONG PRESS F1 TO SETUP PRESS F2 TO LAOD DEFAULT VALUE hi, first of all check the main battery back of ur machine by unplugging from the mains power supply. if machine shuts off, then u have to ...

...wrong by pressing the power button. Now it doesn't reboot or boot up. I tried to pressing F2 to reboot but it doesn't do anything. Any suggestions? Look at the power indicator: If it is not lit, no ...

...monitor model told no PC model told no OS told also PCs with wrong drivers, the sleep mode fails. so turn off sleep fully in the control panel + power settings go to performance mode.;the blow ...