...washer has some fault or a bit jammed, this will demand a lot of power from the Honda. You can try the Honda with no water connection and no gun. Regarding the Honda motor, you should check the ...
Question about 160 CC Honda OHC Engine 21 in
...moved off choke Starts fine when on choke, but when the throttle is moved to run, the engine dies. If it will start on choke and die when choke is taken off...the carb needs to be taken off and ...
Question about Bilt, Tuffy, Rear - Tine Tiller, 4.0 Tecumseh Engine
...washer that uses Tecumseh H30 engine. After pumping the choke bulb on the carb, it will crank, run maybe 5 seconds and quit. Thanks When you get it started, move the choke to the middle, then let it ...
Question about Bilt, Tuffy, Rear - Tine Tiller, 4.0 Tecumseh Engine
choke fully open, but dies after 20-30 seconds Do you mean that you can start it normally using the choke (that would be choke CLOSED), but then it dies immediately when you move it to run (that would
Question about Lawn Mower With Toro Power Tools
...Thanks. Have a Toro GPS5 600 lawnmower. Starts with Choke on, but dies if you move off choke. Also, runs fast and slow when blade engaged. I heard carb for this unit are no longer available. ...
...starts but dies very quickly, especially when choke is moved to "run" position. sounds like it isn't getting enough fuel. take carby off and clean with carby cleaner and air gun. also flush ...
...washer just won't start. But if I put a little gas in the choke area, it starts for a few seconds and then it dies. I do press the handle on the trigger, but still it dies immediately. clean ...
...up. Was running fine but began to lose power and died. Had to choke and keep choke out for it to run. When I apply throttle, it dies. Now it won39;t even start. Repost under ATV for an ...
Question about Crafstman Briggs & Stratton 3000 PSI, 2.7 GPM Powered Pressure Washer,
...starts and runs with the throttle set to choke, but when moved to any run position coughs and splutters, then dies. have checked plug, air filter and cleaned the carb and checked for fuel flow. Any ...
Question about Gas-Powered Pressure Washer - 4 GPM, 3500 PSI, 414cc
starts with choke on, dies when choke is moved to run. carburetor needs cleaning. lots of youtube videos to show you how. The best way to avoid this happening again is to close the valve in the gas ...
Usually answered in minutes!
1,998 Questions
1,006 Questions
778 Questions
1,057 Questions
700 Questions