...power supply is bad--the fuze did not blow, and replacing a couple of bulging caps only led to a flash from a shorted coil and smoke. It is a 12 volt 4 amp and 24 volt 5 amp unit. Any info on where I ...
Question about L32W11 32 in. HD-Ready LCD Television
on the 7 pins on the power supply on L32w11 I know pins 2,3,4 are ground, but the rest I am not sure. 12 volts on pin 1. 24 volts on pins 5, 6 Pin 7 is the ON/OFF to turn the power supply circuitry ON
...power supply board. I did have the +5V. The repair is an 85 cent fuse under the blue transformer, There is a 200mA fuse, green with a "C" on it, at location RB8 (1206 package). I went to the shack ...
power supply first for bad caps, bad solder joints, etc. Please see my basic troubleshooting guide: http://s807.photobucket.com/home/budm/allalbums http://www.fixya.com/support/r5093881-lcd_flat_panel
...power supply board have problems.That the board,where the power a/c cord plug into it.Tries websites like Shopjimmy.com,Ebay.com to buy a refurbish power supply board for the replacement. A friend ...
...power supply. To find directions, search for the replacement part on google. Back-lights can go from anywhere from $60 to $300, depending on the brand, size, etc. If you have 24vdc feeding the ...
power supply no 5 volts and 12 volts b. Main board defective your can replace it will new board or repair c. Check the fuse of 5 V and 12 V. Your LED light voltage is fine. These are only the option i
...power supply that is running 7/24 if the set is plugged in and it supplies voltage to the remote circuit that turn on the main power supply for the tv and hence turn the set on. This is an area where ...
...power supply that is running 7/24 if the set is plugged in and it supplies voltage to the remote circuit that turn on the main power supply for the tv and hence turn the set on. This is an area where ...
Question about MM52110 52" Rear Projection HDTV-Ready Television
...power supply to Backlight inverter connector burned. Replaced cable power supply and backlight inverter and main board. Also replaced TCON board. Standby light is on. 5 volts on power supply board. ...
Usually answered in minutes!
2,410 Questions
1,124 Questions
809 Questions
789 Questions
510 Questions