...PROBE The oven will not come on. I have tried turning off the breaker for several hours. As soon as power is restored the same message appears. What do I need to do? Any codes? Most like the ...
...Power to element relay disabled in cook mode Replace the clock/relay board F-7 Shorted touch pad key sensed for 32 secs. Replace the touch pad/control panel F-8 Shorted meat probe Replace the probe ...
Question about Profile JTP18 Electric Single Oven
...probe inside the oven cavity) The part number is WB23X5340 and it lists for ~$72.00 at your local appliance parts place. Bad news is that you have to pull the oven out of the wall to do this repair. ...
...probe (unfortunately in a glass of water, thus worsening the moisture problem.) We cut the power to the oven, but when it was back on, the oven still showed the same message. Finally, I ...
power source before removing the panel from behind the console. If its an F2 ERROR CODE, The F2 error indicates an open circuit in the oven temperature probe. if Your range has a resettable thermostat
...POWER to the range and then open oven door and locate the pencil like probe protruding from the back of the oven cavity near the ceiling. ? Locate and remove the screws that are holding the sensor to ...
...probe so you can insert probes into the ribbon cable connector, testing one wire at a time for continuity. 4. Drive Board Check whether drive board components are burnt or cracked. Check component ...
Question about JJW8130D Electric Single Oven
power source before removing the panel from behind the console. If its an F2 ERROR CODE, The F2 error indicates an open circuit in the oven temperature probe. Your range has a resettable thermostat in
Question about JJW8130D Electric Single Oven
power it on, we get the message EAA1 and it shuts off. Take off the electronic control unit and make sure the probe is still connected (unplugged and check the pins for damage). After reassembling the
Question about 2009 DB9
...or other information displayed. Any idea which fuse is involved? The message center receives power from several fuses, so it may not be a single fuse that is causing the issue. Here are some ...
Usually answered in minutes!
1,163 Questions
465 Questions
395 Questions
390 Questions
353 Questions