Questions & Answers for: poulan pro mower blades wont

Poulan Pro riding mower jerks in forward and the blades engaged Starts fine, runs fine, but when you run in forward and have the blades engaged it jerks every few seconds like its slipping, any ideas?

...lever, which engages the mower blades to turn.Poulan model PXT12530 sounds like the belt is stretched, check the belt or get a smaller belt, doesnt take but a quarter inch to effect ...

...poulan riding lawn mower. the belt is attached but the blades dont spin very fast. there is no debris in the blades SOUND LIKE THE ENGAGING SPRING IS OFF OR BROKE OR YOU COULD HAVE THE WRONG BELT ON ...

15.5 hp Poulan Lawnmower stalls when I push in the clutch or try to engage blades check the safety switches

...poulan pro series pdgt26h48 and the blades arent engaging just put a new drive belt on blades will not engage when i pull the knob you must make sure the drive belt is tight. you could have a bad ...

...poulan pro PR1842STC; the blades won't stop turning after I disengage the mower belt. Before when I disengaged the mower belt, within seconds the blades would stop turning regardless of the ...

...mower up high enough to see the blades. Are they real clogged, remove the and clean them. Check all you belts to be certain one in not broke or real lose. If you don't see an issue, put it back ...

poulan pro engine dies when blades are engaged poulan pro 48 20hp engine boggs down and dies when blades are engaged Something may be wrapped around the blade shaft under the mower deck or maybe the ...

poulan pro 17.5642, 6 speed, model pb175g42. put in reverse while mower was engaged and it died. now i cant get it to start. clicks hair and that is it turn PTO off many mowers now have a button that ...

...poulan pro riding lawn mower was cutting fine then I needed to reverse so I disengaged the blade, reversed, and once I was ready to go again, the second I tried to engage the blade, it died. I've ...