...is normal but inspect your fuel line for cracks sounds like your sucking air hope this helps I have a Poulan PRO PP4620AVX can not get it started. I have replaced the spark plug and it pulls
Poulan Pro 18 inch saw. Once the unit is warm it Poulan Pro 18 inch saw. Once the unit is warm it is really difficult/impossible to start. It also does not idle well. Any suggestions on how to correct
Question about Pro 42CC 2 Cycle Chainsaw, 18"
Poulan chainsaw is hard to start and will not re-start once it is warm. Any suggestions besides junk it. Spend $ 40 for a tune up at a local chainsaw seller/mechanic. Most Stihl outlets are very good.
...poulan pro 42cc is hard to start ,,, its1 year old an i'm not sure if its worn out from alot of use or if its with the ignition throw it out and buy a new one this is a throw away scoiety we live in ...
Question about Pro 42CC 2 Cycle Chainsaw, 18"
...Poulan-Pro 295. Very hard to pull cord to start...feels like too much compression. The recoil works fine but it is hard to turn engine over to start. Feels like too much compression, or on that order ...
Poulan Pro Chainsaw, PP3516AVX Replaced fuel line since it broke from inside. Thought that was the problem since chainsaw was working great. It started with hard to start, saw the priming bulb was not
poulan problems Hard to start cold Poulan Pro Weed Eater. 31cc PPB200E, Crancks good, runs as Long keep chock on , New Carberater, New fuel lines, New fuel filter
Question about Pro 42CC 2 Cycle Chainsaw, 18"
...hard to start again no offence thats a made in china saw poulans are but it might just need carburator cleaned and new filters and plug wouldnt hurt to check the clutch springs either there bad to ...
hard pull start this is anew saw very hard to pull strart The Poulin has a very hi compression you need a good harm.
why ispull start hard to pull WHAT KIND OF QUESTION IS THIS PLEASE VERIFY SIR
Usually answered in minutes!
1,998 Questions
1,006 Questions
778 Questions
1,057 Questions
700 Questions