poulan 3314 4 weeks old starts great idles fine, problem is when im on full throtle and cutting it will die and and splutter and miss and then stop. when it is not under load it revs fine. It will cut
my saw will start but dies immediatly it has always died often i turned up the idle that helped. then i was using it it died then i was never able to get it to do more than sputter for a few seconds ...
Question about Pro 16-Inch 38 cc Anti-Vibration Chainsaw #PP3516AVX
Then it starts to smoke and run poorly and then die. Starts then.... you hit the trigger... ba ba ba .... dies ? Check fuel filter in tank, make sure air cleaner is clean. Make sur your mix is correct
Question about Pro 42CC 2 Cycle Chainsaw, 18"
Poulan pro 4218 avl, starts (sometimes) then dies, smells like its flooded? New spark plug, fresh gas, still no luck keeping it running, any clues? thanx may be choke problem,about 20.00 for repairman
...Poulan will start up but then when I try and give it more throttle it dies or even when I let off the throttle to idle it will die. Is this fuel line o dos the carb. need to be cleaned? How do I ...
Question about Wild Thing 2375 18" Gas Chain Saw 2.5 Cuin
...chainsaw (model poulan 18" wildthing chainsaw (model 2375le) will run for about 20 minutes and then shuts off and wont start till it cools down. I've done minimal maintinance to it. This ...
Question about Wild Thing 2375 18" Gas Chain Saw 2.5 Cuin
...chainsaw starts up it will idle the min. you disengauge the high idle on the choke it runs for about 3 seconds and then dies like it ran out of gas When it dies pull out the spark plug. If it is dry ...
chainsaw runs then dies Starts up with choke out but then it dies. Then it floods it self Carburetor needs to be overhauled and replace all fuel lines and fuel filter.
Question about Pro 42CC 2 Cycle Chainsaw, 18"
...when using won't idle always dies then hard to start again no offence thats a made in china saw poulans are but it might just need carburator cleaned and new filters and plug wouldnt hurt to
Question about Pro 42CC 2 Cycle Chainsaw, 18"
...POULAN PRO CHAINSAW.STARTS AND RUNS FINE FOR 10-15 min. THEN DIES AND WON'T RESTART UNTILL COLD. THEN IT REPEATS THE SAME PROBLEM. If it pulls easier than it used to when you try to start, you have ...
Usually answered in minutes!
1,998 Questions
1,006 Questions
778 Questions
1,057 Questions
700 Questions