...Poulan 18" chainsaw locked up. Is this something that I can fix myself? Hi there . You can try to remove the recoil starter and turn the flywheel by hand . If it turns by hand you have to replace the ...
Question about Pro 42CC 2 Cycle Chainsaw, 18"
Brand new saw, started it and it seized, piston is now seized Did you mix the proper amount of oil with the gasoline? Are you sure the piston is seized and it isn't just that the chain is too tight ...
Question about Wild Thing 2375 18" Gas Chain Saw 2.5 Cuin
Poulan chainsaw rope/cord jammed/stuck Help! We just bought it and this happens. Are these chainsaws that cheap? How can we fix it? did you mix the gas and oil properly and seize the engine if you did
Question about Pro 42CC 2 Cycle Chainsaw, 18"
...poulan pro 4218 it was running great when i put it away last year . went to start it this year put in fresh fuel i have a spark used starting fluid doesnt even try to start what gives? If there is ...
engine turns hard You may have seized the engine. Pull the spark plug and shoot some WD40 in the spark plug hole and pull the rope several times to see if it loosens up.
Question about Pro 42CC 2 Cycle Chainsaw, 18"
...Poulan Pro chainsaw If it was not run, or was shut down before it seized, drain the fuel refill with 2 cycle mix (double oil if the saw had been run). Start it and run under light load till empty. if ...
Question about Pro PP5020AV 50 cc Gas Powered 20-in Chain Saw with Case
...Poulan pro chainsaw recently. It starts very well. When I stop using it, it makes a metal rattling noise inside the saw engine. It has been doing that for a few uses. Now after operation for a while ...
Question about Pro 42CC 2 Cycle Chainsaw, 18"
why will engine not turn over after repairing starter rope? starter rope broke and now engine will not turn over if it wont turn over ,then it is seized.
Question about Pro 42CC 2 Cycle Chainsaw, 18"
how to check timing of poulan 3314 chainsaw unable to pull out starter cable probably seized from lack of oil
Question about Pro 42CC 2 Cycle Chainsaw, 18"
Flywheel on poulan chainsaw will not turn. Could this possibly be a sheared flywheel key? more likely is something is jammed up or its seized
Usually answered in minutes!
1,998 Questions
1,006 Questions
778 Questions
1,057 Questions
700 Questions