...poulan chainsaw 18"poular pro 42cc wildthing chain saw gets sparks and fuel but won,t fire at all fuel mixture is correct Start at 1.5 CCW form lightly seated then tune for performance like this: ...
Question about Wild Thing 2375 18" Gas Chain Saw 2.5 Cuin
Chain saw won't start - pull starter pulley hard to pull? If it worked fine the last time you used it, then pull the spark plug and try pulling the rope. See if it's easier or if gas shoots out of the
...Poulan 14" chain saw has become difficult to My Poulan 14" chain saw has become difficult to start. Problem is with the pull rope. It no longer pulls out smoothy, but instead, it pulls out in ...
Question about Pro 42CC 2 Cycle Chainsaw, 18"
Poulan 42 cc chain saw that is hard to pull the rope like the compression release is not working. How do I repair it?? Built in 2007 I do not think they had a compression realese on a saw that small, ...
...chain saw started and idling? What are next steps to cut tree limbs and oil the chain? This chain saw was given to me without a manual. If you are a complete novice you should seek some training ...
...increasing the compression ratio causing this to happen. When the spark plug is removed it is very easy to pull on the cord in any means. A inspection is due of this engine or a new chain saw is ...
Question about Wild Thing 2375 18" Gas Chain Saw 2.5 Cuin
Starter rope hard to pull. It's not smooth and takes a lot of effort. Make sure the brake is off and retest. If brake is off and still difficult to pull, remove the side cover, chain, bar and ...
Question about P3314 14" Gas Chain Saw 2.0 Cuin 33CC 2 Cycl
...starter rope why?? hard to pull and recoil This could be a lot of things. IF the fuel mixture is not right then the wear on the engine is excessive. Take the spark plug out and see if it is easier to ...
Usually answered in minutes!
1,998 Questions
1,006 Questions
778 Questions
1,057 Questions
700 Questions