Questions & Answers for: pool pump timer moving

Question about Hardware & Accessories

1 Answer

pool pump off Red indicator light glows on timer when in on position and pump runs. Move to off position and it will not shut the pump off. If your timer is not turning off the pump its probably wired

Ad

Question about Polaris 280 In - Ground Pool Cleaner with Booster Pump

1 Answer

...pool sweep wheels turn very slowly, and there is not very good pressure to fill the bag. There is good pressure to the back-up valve. Thank you. Are you sure of adequate pressurre to valve? 1.Clean ...

Ad

Question about Timer T12404R Pool & Spa Controls with One T104M201 and T104M

1 Answer

...pool pump at the breaker... Any suggestions on what the problem might be? If the pool pump timer is not working, first look and see if the clock dial is moving, if not then you need to check the ...

Question about Timer T12404R Pool & Spa Controls with One T104M201 and T104M

1 Answer

...pool pump is OFF, use tester and check voltage across terminals 1 and 2 on pump side When cleaner is OFF, use tester and check voltage across terminals 1 and 2 on cleaner side What test results show: ...

Question about Timer T12404R Pool & Spa Controls with One T104M201 and T104M

2 Answers

...pool pump. You can only manually turn it on and off. When trying to set the time, the dial is loose and does not stay in position and does not turn when the pool pump is on. The trippers work if I ...

Question about T101P3 Pool Timer IndoorOutdoor 110V Plastic enclosure

1 Answer

...pool pump. I have one start and one stop time in a 24 hr period. I have to manually start the pump at the timer in the morning, adjust the dial to set the correct time, and then it runs fine until it ...

Question about 4001-0G Defrost Timer

1 Answer

pool pump for many years. Assuming you have Paragon 4001 40 amp 120Volt timerBy-pass the timer so only pool pump is connected to breaker.To do this, move wire from terminal 2 and connect to terminal 1

Question about 220v T104p Swimming Pool Pump Timer Switch

1 Answer

Pool pump breaker tripping We had a Hayward 1hp pool pump wired to a Intermatic T104p timer and then which was wired to the panel box. The pump bearing went out and froze. We purchased a new pump ...

...pool equipment and when it is off the pump will not run in manual mode. Since we move into our house our pool timer only works sometimes almost like it is on a switch. I replaced the clock mech but ...

...pool pump on and nothing is moving The timer motor may be defective, pull the timer and see if the motor turns. check power to unit if good check that no debris is in timer [ bugs ] and check ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Top Hardware & Accessories Experts

Brad Brown

Level 3 Expert

19187 Answers

ADMIN Andrew
ADMIN Andrew

Level 3 Expert

66963 Answers

Steve Pack
Steve Pack

Level 3 Expert

7128 Answers

Are you a Hardware & Accessories Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...