Questions & Answers for: polo gti problems

speedometer seedometer in my 2004 vw polo seems to hve a problem when driving it drops to 0 n straight back up to the speed im doing again your gauge is faulty. yours is operated by a circuit board ...

...Polo GTI V Reg - Warning Light A yellow warning light has come up - it looks like an engine with a flash though it and says 'CHECK'. What does this mean? Hi! I believe that is the check engine light. ...

...polo 1.4 tdi and when i start the car it automatically goes up to 2000 revs and doesnt come back down. when i drive the car and stop at a junction and the brake is pressed it comes down to about 1300 ...

...polo gti year 2000. ther is an intermitten problem as if thers a fuel blockage. when driving in low revs the car shudders as if its not running on all cylandars. and sounds it aswel. i have put a new ...

i have a vw polo and the EPC warning light has come on what should i do? Check your brake lights.if the bulbs blow this can induce a brake light switch fault,also the switch itself is a very common ...

...polo gti after long journey did not click over changed starter motor all ok few weeks later after long journey same problem told by mechanic wiring fault starter motor burnt out REPLACE THE POSITIVE ...

( INSP ) on the km part what is mean? hi my car is VW polo my problem ,when i opreat it the world (INSP ) write on the km part what is mean ? Means that your VW needs inspection , oil change or ...

polo gti wont start its been put on a computer and said the immobilser locked,ive had that bypassed.still had a problem the coil pack has now been changed and spark leads because they were corroded ...

Polo GTI, which is drinking fuel I have a 2001 Polo GTI, which is really drinking petrol recently, for example today I have done about 30 miles, and it has used a quarter of a tanl, any ideas what the

polo gti battery light wont start I was driving my polo gti 6n2 when the battery light appeared on my dash then when i stopped and tried to start it again it wouldnt start, so i tried to bump start ...