...fuse is blown, located under the back pannel. Mine just did the same thing. Problem is the problem with my PSW10 goes beyond the fuse. I have contacted Polk tech support to help me trouble
Polk Audio PSW10 not working My PSW10 will not work. It has been idle for a few months and there is now no power. I have tried another outlet with no positive results. I just read this same problemin ...
Question about PSW10 Subwoofer
...Polk psw10 sub woofer to yamaha rx-v663 receiver I have one rca subwoofer connection on amp and a left & right rca on speaker. I would assume a y connector would be the answer. I cannot fine a 1 to 2 ...
Polk Audio PSW10 electrical board smoking I have the polk audio 10" powered sub woofer and it blew the fuse, I replaced the fuse and it blew again. I plugged it in while I had it apart and the back of
Polk Audio PSW10 Subwoofer hooked up to my Onkyo TX-SR608 receiver and I can not get any sound from it. Meaning I can hear the humming, but no audio at all. The reciever have an feature which test all
my receiver has one pre-out will a psw10 work yes but a sub woofer out is better. You may have to crank up the sub response. If it has a level on the sub with a crossover set the cross over to around ...
Question about PSW Series PSW10 Black 10-inch Powered Subwoofer Each
Where is the fuse in Polk psw 10 subwoofer? You will have to remove the plate amp and look on the pcb, it is generally located near where the main power lines come in. If you still can' find it ...
Question about PSW Series PSW10 Black 10-inch Powered Subwoofer Each
...Polk Audio PSW10 10" Powered Subwoofer, 35Hz-200Hz, 50W Continuous Power, Single with my Yamaha ATS-1050 Sound bar? Yes. Connect a standard rca cable from the audio out jack of your yamaha to the ...
Question about PSW Series PSW10 Black 10-inch Powered Subwoofer Each
I have polk audio psw10 subwoofer 110 volts and how conect to 12 volts in my car thank you need a/c converter
Question about PSW Series PSW10 Black 10-inch Powered Subwoofer Each
Polk Audio PSW10 10’’ "&there’s no sound the standby light is red. Connect onkyo av-amp sub pre-out to line in and enter Onkyo av-amp speaker setting then subwoofer level calibration finally set +10db
Usually answered in minutes!
6,442 Questions
5,455 Questions
4,073 Questions
2,449 Questions
2,268 Questions