ford fiesta 1.4 o2 reg . ford fiesta 1.4 02 reg missfire/holdback when pulling away Common thing, water drips from the windscreen washer jets onto the Ht leads and into the spark plugs, New coil, ...
2007 Ford Fusion shaking when stopped 2007 Ford Fusion - when stopped car is jumping, shaking and idling rough. Sounds like a missfire, check spark plugs and HT leads from coil, they suffer from water
...plugged in carb. Take off carb and take apart and spray with carb cleaner. Use jet tools and clean out jets, spray with cleaner real good then put back together. You may need to get a carb kit if ...
Question about 2005 XL 1200 C Sportster Custom
...jet. I'd take the top off the carb and lift the slide out. Once I got the slide out, remove the needle. Put a 0.020" thick washer on the bottom side of the needle. I have found that a 3mm flat washer ...
...washer fluid is only spraying out of one jet, and not second jet, or the second wiper. spray is also excessive on the jet that is working. it is not frozen, and hoses are properly connected as well. ...
Question about 2001 Sunfire
washer only start if i put a litle bit of gas true the carburator but dont stay on it start for a few seconds and turn off sounds to me like some of the jets in the cab are plugged remove the carb and
Question about 1986 Century
washer fluid jets are plugged possibly and will not allow fluid to discharge. Take a small wire or needle and stick into the jet end where the fluid comes out and it should spray after that if that is
...plugged in a new mulitfunction switch and still nothing. rear washers work fine. one fuse controls the one pump for both front and rear washers. check the washer line it maybe blocked. un plug the ...
...washer turns over and begins to catch (5-10 revs), but quickly dies. I suspected a carburetor or fuel line problem, drained and cleaned the carburetor and jet, put in new stabilized fuel - and still ...
...washer won't stay on with chock pushed in stays on chock pulled out see video It has a plugged jet in carburetor remove carburetor and clean all the jets that should help. If not it may need valves ...
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions