Questions & Answers for: piston ring position

Question about 1991 Aerostar Extended

2 Answers

...WHEN ENGINE IS WORM STARTS MISSING NEW TUNE UP the compression of the engine is low .check the piston and the piston rings ,check and replace the worn out piston rings adjust valve clearance. ...

Ad

piston ring, what is the required gap for the ring? Also, does it matter which way the piston is positioned in the cylinder, there is no arrow or difference that I can tell by looking at it. It's been

Ad

piston and rings, my problem is that the ring are different, do you know which one go on the top, one is more black or dark than the oder. Most rings are marked in one manner or another. They may have

...correct place on the piston by a small pin in the ring slot and you will neen a piston ring shimming assembly kit to keep the pistons in the correct position while you slide them into the cylinders

...ring on the piston groove (don't worry), it should look like the ring is side by side with the piston. With that in place, roll the ring along the groove, making sure the opened end flings on top of ...

...piston with the wooden handle of a hammer. when i say stagger i mean the gaps in each ring are in a different position so as not to create a bypass of pressure or oil. if you use the compressor the ...

piston and hold the ring in with your fingers gentle push the barrel over the piston and the taper at the cylinder base will hold the ring in as you continue to push the barrel down if you have failed

is the lower the piston ring number the bigger the ring no rings are numbered in the position they have to go on the piston the number can also indicate that it has to go on facing up

piston ring on husqvarna model 240 chainsaw. I would like to know if bevel edge on ring ends face up or down on piston Most 2 cycles have a pin in the piston groove that keeps the ring from traveling.

...Piston from the bore to check rings end gap orientation. And I set the position of rings Correctly. Should I change the Rings now? Because I have heard that rings once inserted into bore, lose their ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Top Cars & Trucks Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

john h

Level 3 Expert

29494 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Are you a Cars & Trucks Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...