Questions & Answers for: pipe cable locator answers

Ad

pipe and power cable are all enclosed in a larger pipe. Any ideas? It appears your aqua-stop has failed in this instance. For replacement parts - head on over to PartSelect.com or RepairClinic.com and

Ad

...gas recirculation (EGR) valve ? The engine coolant temperature (ECT) sensor Disconnect the fuel pipes from the fuel pipes. Remove the distributor cap and reposition it out of the way. Remove the ...

Ad

pipe should be free to move a limited space but it will be enough to get the starter out of the hole that it is in. Remove the aluminum shield from below the area where the starter is and remove the 2

Question about 2001 Aztek

1 Answer

...pipe cap. Connect the negative battery cable. Inspect for fuel leaks with the following procedure: Turn ON the ignition for 2 seconds. Turn OFF the ignition for 10 seconds. Turn ON the ignition. ...

Question about 2000 Sephia

1 Answer

...cable and see if it has a part number on the outer sleeve. this may be an easy fix it depends on routing through the firewall. if this is a hydrolic clutch the master cylinder is been leaking or ...

...cable. Properly drain and recover the coolant to a level below the thermostat. Unfasten the cover-to-outlet pipe bolt, which is accessible through the exhaust manifold runners. Raise and safely ...

Question about 1992 DeVille

1 Answer

pipe assembly. Remove the flexplate inspection cover. Disconnect the solenoid 'S' terminal nut and battery cable nut. Unbolt the starter motor mounting bolts, and remove the starter motor. Fig

...pipe nuts to specification. Install the upper heat shield. Attach the oxygen sensor connector. Fill the radiator with coolant until it comes out the heater hose outlet at the thermostat housing. Then ...

Question about 2006 Aerio

1 Answer

...cable at the transaxle Starter Exhaust No. 1 pipe bolts Support engine with lifting device. Engine under covers Exhaust No. 1 pipe and exhaust No. 2 pipe Lower stiffener Left and right ball joints ...

...cable.
Drain the fuel from the tank by pumping the fuel out through the fuel tank filler.
Remove or disconnect the following:
Fuel filler cap
Raise and safely support the vehicle.
...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Top Washing Machines Experts

Gerry Harvey
Gerry Harvey

Level 3 Expert

1479 Answers

Marvin
Marvin

Level 3 Expert

84625 Answers

Brad Brown

Level 3 Expert

18060 Answers

Are you a Washing Machines Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...