Question about Black Gamer Case w/ Maximum Filtered Airflow Meshed Side Panels and LCD Readout, Front USB&Fir... (CASCINP9001C4)
uploaded is the CD Connection Cord attached to the front panel multifunctional Display, There are 2 pins to fit into the IDE cable feet which goes to "CD Rom feet 25 (Positive) and 26 ( Negative)" The
...probes are touched together) Put a probe onto one of the outside pins and use that as a reference to being pin 1, then put the other probe to pin 2 The move the probe on pin 1 to pin 3. so if you ...
...is under the dash, on the driver side. It is white, and sort of oblong, with 2 rows of femal pins. It is NOT recommended to start probing in this connector to "get a code". You may damage the ...
...circuit, and you now have a different reading on the computer, or so it thinks. I hope you used a pin pusher, and didn't cut/wire nut the probe wires, because you just added a lot of resistance to ...
...of the two probes in the right rear corner. they should be white plastic insulators with stainless pins . Scale may be built up on the pins. Check for corrosion on the probe assembly connector on
...connector with wire colors Orange/White...Blue/Light Green...And Black./White...using two safety pins push one into the rear of the in-place connector into the Blue/Light Green...The other into
...signs of a capacitor with a slight bulge on top, if you see either one with a bulge unsolder one pin of the capacitor look at the capacitor side for the voltage and uf (farad) set the DMM set it
Question about R5450-MD1GD3H/LP RADEON HD 5450, (1 GB) 128-bit DDR3 PCI Express 2 0 x16 HDCP Ready Low Profile Vide Video Card
...probes on the fan's pin header pins(one on each pin), be carefull not to short the two pins together. The meter will give you the voltage reading. If you get a positive voltage reading, the red probe ...
Question about 2004 Explorer
...voltmeter they can be tested...The TPS is bolted to the throttle body and has a 4 wire connector...Pin 1=signal out..A Gray/White wire...Pin 2=+5 volts...Yellow/White...Pin ...
...pin on the battery? The battery terminals have a plus (+) and minus (-) symbol somewhere near the terminal studs. If you cannot find them, use a multimeter set to a proper DC Range. Place the probes ...
Usually answered in minutes!
19,138 Questions
12,216 Questions
7,310 Questions
7,277 Questions
5,472 Questions