...Pin Pad is ok but it has to go back to a VeriFone supplier to download the operating software. With the Pin Pad not being used for 1,5 years the internal battery in the Pin Pad will have gone flat. ...
...side is siezed. i learned something new about the brakes on the 05 canyons. you need to change the pins with the pads. sounds like you are having the same problem as me. when you change the pads get ...
Question about PINPad 1000SE Network Terminal
...will only work with a credit card terminal IE: Nurit 28xx, 30xx, 80xx and also software developed specifically for the pin pad to work. You can only use that pin pad with a 9Pin serial cable to
drivers door panel off to replace tha window motor their are no screws on these door pads just push pins take a fiber stick or a flat head head screwdriver add stick between door and door pad starting
...drivers to push pistons back in and a pair of pliers to remove clips off pins holding pads and a small long punch to tap pins out, then clean top and bottm of caliper where pads sit, use small steel ...
can't give you exact and helpful information. Most of the rear pad retainer pins need to be driven out with a small pin punch and hammer. Some of the newer front pins unscrew with a hex or torx driver
...insert brake pad(s) into that side press opposite pistons back into the caliper insert brake pad(s) replace metal spring and slide pin back through replacing cotter pin repeat for the other
Question about 2003 VL 1500 Intruder LC
pad pin tips. Snap the brake pad cover onto the top of the rear brake caliper....Pump the rear brake pedal until the pedal feels firm, indicating that the brake pads have closed around the brake rotor
...pads from a seized caliper slide pin. Check for dry/ failing u-joints at rear of gear box if you have a drive shaft. Seized caliper pins are indicated by one pad badly worn compared to the other
Question about 2003 VL 1500 Intruder LC
...pad pins are out inspect them for grooving and wear and measure the pin diameter in an unworn area, and then in the area of any grooving or wear, and if wear is more than 0.015 in. (0.38mm), replace ...
Usually answered in minutes!
2,410 Questions
2,254 Questions
1,646 Questions
1,423 Questions
1,438 Questions