...Fuse F9A05 will read open in circuit but F9a04 wont so its best to lift one side of those two pico fuses out of circuit to check them. (* % of the time a 22 code in that chassis its the ICs having ...
...IC801 and IC802 which are both STK392-570 and you will also need to change the two 5 Amp pico fuses which are F9A04 and F9A05 they are both % amp pico fuses. All parts are located on the center ...
...pico fuses F9A04 and F9A05 if either one of those picos are open it means the convergence Ics are bad along with the picos. Your set uses two STK392-570 ICs and the two picos are both 5amp picos. You ...
...F9A05 are open the convergence ICs will need to be replaced as well as the two pico fuses. You will need two STK392-570 Convergence ICs and two 5 amp pico fuses. You ca get the replacement parts at ...
...Any guidance? Thanks Phil Check these two green pico fuses F9A04 and F9A05 to see if they have continuity, if they dont have continuity the Convergence iC and those two picos will need
Question about WS-65809 65" Rear Projection Television
...same time. What does that indicate? tHats indicating a short. Check the two green pico fuses F9A04 and F9A05 on the center board if they are blown replace the two 5 amp picos and the convergence
Question about WS-55511 55" Rear Projection Television
...protection shutdown. Check The two Bright green pico fuses on the center board for continuity F9A04 and F9A05 if they dont have continuity. The convergence ICs and both picos will need to be
...pico fuses F9A04 and F9A05 on the "Center Board" if either of those two fuses are blown then convergence ICs are the reason its shutting down with a 22 error code.The pico fuses look just like ...
...pico fuse and they are still open. so they say it must be my ic yes when either of the two Pico fuses F9A04 or F9A05 fail its caused by the convergence IC. replace the IC and both pico fuses should ...
Question about WS-55511 55" Rear Projection Television
...pico fuses does the Mitsubishi ws55859 use? My email is [email protected] There should be 3 fuses...the picture is attached. The two that fail most often are the F9A04 and F9A05. Depending on the ...
Usually answered in minutes!
2,410 Questions
2,254 Questions
1,646 Questions
1,423 Questions
1,438 Questions