Philips 42" plasma TV mod 42PF5321D/37 and i am trying to connect the yamaha RV1103 receiver to it as well as my speakers to the receiver. Hellpppp! Thanks K YOU SHOULD BE ABLE TO RUN SOME PHONO LEADS
...Philips 42 in plasma screen tv that is out of warrenty. When brought for repair, they told me I need a Y Main Board, upper and lower scan and it would cost $600.00. We have already had two firmware ...
...is a philips plasma model 42pf5321d/37 thanks for any help... s.rodz when electronics get wet they tend to short out. so some part of the electroncs is damaged. you will have to take it in for ...
Question about 42PF9630A 42 in. Plasma Television
...Philips 42 " 42pf5321d/37 bought 11.06 . My av went dead cant bring up menu or anything on the screen. I unplug the set, plug it in and the green light comes on , theres a few seconds and ...
Question about 42PF9630A 42 in. Plasma Television
...Philips Plasma tv 42pf5321d/37 with sound but no picture The other night while watching the tv there was a very load pop and the picture and sound went out and the LED on the front started blinking ...
Question about FTR-9964 Tuner/Receiver for Plasma
Tv wont power on. red light keeps blinking (Philips 42PF5321D-37 Plasma TV ) line not working will prob be a voltage regulater transister
...philips plasma model number 42pf5321d/37 is finally not turning on. led turns green and then it flashes red.What are the most common components causing this? Hi, One of the PCB's inside has an ...
Question about FTR-9964 Tuner/Receiver for Plasma
Philips Plasma model number 42PF5321D/37. Most likely a power supply problem. If it's covered under the warranty take it in right away and have them fix it. If not a good Philip's service shop can fix
42PF5321D/37 black screen and red light flashes.unable to turn on. sonia Power supply board is dead.Tries websites like Shopjimmy.com,Ebay.com to buy a refurbish power supply board for the replacement
Question about 42PF9630A 42 in. Plasma Television
...42PF5321D/37 will not power on. I replaced the fuse on the power supply board with a 3 amp (that's what it looked like, but I'm not sure it was the right size because it was burned 42" ...
Usually answered in minutes!
6,442 Questions
5,455 Questions
4,073 Questions
2,449 Questions
2,268 Questions