...plug the hole, i used a plastic plug, the rest of future water should evaporate. the danger is corrosion may make the plugs hard to remove, use a rust penetrating oil a day before removing the
penetrating oil or PB blaster. spray a good amount and let it soak overnight. this will help loosen up the piston rings which are probably siezed to the cylinder walls. you will also need to drain and
...a hammer. Penetrating oil (Liquid Wrench or PB Blaster) will assist in removal. After that...the worst of the hard stuff is done and you can continue on to what you will. Please vote on this
penetrating oil through the spark plug rotate the piston several times and re-apply the penetrant. Lean the saw sideways with the fuel side down and the exhaust side up, overnight. Pull the start cord
...penetrating oil into the spark plug holes and let it soak for at least an hour. Then, carefully work the plug back and forth until it comes out. The problem that I have experienced is that the ...
...penetrating oil down hole let sit for a day, take small hand held propane torch and heat up outside cylinder wall not to hot. take small punch and insert thru spark plug hole gently tap with hammer ...
...way. Clutch is threaded onto a threaded section of the crank. Apply penetrating oil, get hammer and small sharp piece of wood and whack it counterclockwise to remove it. Anything else, just post
penetrating solvent into the plug hole, took left cover off and turned engine back and forth with socket/ratchet. Got the engine to turn over after a few minutes. Then about an ounce of Marvel Mystery
...penetrating oil into all the spark plug holes. Jack up the car and remove the starter. Thru the starter mounting hole you will see the teeth on the fly wheel or flex plate. Using a large flathead ...
How do get the valve(s) unstuck on my JD 130? try spraying penetrating oil down spark plug hole but more than likely need to do a tear down
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions