...96 97 98 99 00 01 02 03 04 05 06 07 08 09 10 11 12 13 14 15 16 17 18 19 20 21 19 19 49 vin ECU 30 Block code Spider leaks due to lines or regulator, where regulator is not part of the spider and can ...
...96 S-10 that will not link to scanner. Scanner work on other GM's and all othe cars/truck i have tried it on. Dont know whats wrong. THERE IS NO POWER IT THE OBD2 CONNECTOR.CHECK THE FUSES.IF U DON'T ...
...pcm! And you are looking for the like years. I think 96-2004. there are minor changes in the engines through the year ranges but if you are going to switch it all over then it will not be that big of ...
96 s-10 4.3, the truck idle's fine. Runs under a load fine, but when I hold the throttle steady I get a miss.. It will run like that until it sets code po300.. it has new wire's, plugs,cap rotor. You ...
96-99 S10 1. Rotate the key to the start position to attempt to start the vehicle (the vehicle will not start). Allow the key to return to the all position (same as if the vehicle would have started).
...96 chev s-10 to pass inspection due to Not ready codes. I recently change the battery and have driven the veh about 200 miles. Autozone checked and said it was all good but the state inspection ...
Question about 1996 S-10 Pickup
...96 and newer will need a scan tool. on some obd vehicles pre1996 it would usually flash code on the dash u but on obd ll cant do it/////////// the second link shows how to do the gm 82-95 obd code ...
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions