...pb blaster and w/d 40 with no results. Please advise my best solution. Yours has rusted in place. Spray your PB Blaster and tap the bolt at the same time. This works the penetrant into the threads ...
...assembleys is PB BLASTER available at your local parts store. spray each latch really good one at a time, then open and close door 10 to 15 times. trust me PB BLASTER takes care of this 90% of the ...
...PB Blaster in the cylinder to free up the stuck exhaust valve. Leave the sparkplug out and spray the cylinder good with PB Blaster and let it set for 20 to 30 minutes. Turn it over several times and ...
...PB Blaster to penetrate it and use a small three fingered gear puller. Be very care full not to over force them, or sense your replace the fauset you can cut through the valve cover behind the handle ...
...PB blaster on over night and using a axle hammer remover. Is there a trick to this is heat the last resort? need detailed pictures of how to change rear wheel bearings on a chevy equinox U can try a ...
Question about 2000 Sierra 3500
...pb blaster.spray around where the hub and rotor meet .let it soak-maybe overnight.then use a block of wood and a heavy hammer(if you dont want to damage the rotor)work your way around the rotor.clean ...
to replace...but first try spraying a little PB Blaster on key and into key slot to lubricate...other solutions may damage...but PB Blaster will make cleaner connections and movement...Hope this helps
Question about 2000 Sierra 3500
...PB BLASTER will "cut the crud" and help... I keep several cans in my shop at all times!! righty tighty - LEFTY LOOSEIE.. Use a 1/2 inch drive power bar and a 6 POINT "impact socket" Blaster PB ...
...pb blaster move the switch back and forth get the pb blaster into the switch body and work it back and forth try putting it on after this and adjusting it is it starting now? if not take it of use a ...
Question about 2000 Sierra 3500
PB Blaster. Then go under the hood and before pulling cable, through the fire wall bushing.....Attach strong nylon string or 14ga. wire to pedal end of cable, string is to be attached to new cable, to
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions