Questions & Answers for: paul wiring ideas

...ideas would be great Hello! From your description it sounds like the warning light switch has either come adrift or stuck? If you examine the hand brake area look around for possibly a White plastic ...

what posts on the connector. Can enyone help. Our unit is a Shure MX412/D. desk Top Unit. Thank You Paul Red: pin 2 Black: Pin 3 Shield: Pin 1 All others: not connected

...ideas as to whether the lower element is shorting out the oven? Thank you, Paul sounds like that element is getting a "hot spot",high resistance area, will oven operate w/o that element in place?you ...

the safety switch and key work. Any ideas? Thanks, Paul Check your starter fuse..follow ignition wire to starter..there is a fusable link inline. make sure u have power all throughh line to starter. :

...your way thru the house, checking the wiring and tightening the wire nuts, or connectors. Enjoy :) ...

...then magnetron is faulty replace it & set air gap to 0.010 " and reconnect kill wires cheers ...

...ideas cheers Paul Dirty contacts in the ignition switch contact base. You may not be able to disassemble and clean your switch but you can check the wires for continuity. Your handle bar kill switch ...

...ideas paul It sounds like a loose cable on the laptop where the laptop screen is connected on the inside of the system screen is either disconnected via the wires running to the display port on your ...

...Paul Custom Silverburst, and it's pretty new and has worked great until now. It seems my bridge pickup lost tone and volume for some reason. My volume and tone knobs are cranked and my amp is on ...

...ideas would be a great help Sounds like a lean condition. If possible monitor O2 sensors to verify condition. Does it run well at idle/ no load? Check fuel pressure , replace the fuel filter if it ...