Questions & Answers for: a path is too deep Vacuums

...Cannot figure out how to get the unit apart to replace the brush drive belt. Hoover Steamvac wide path spin scrub Hoover steamvacs don't use belts. If the brushes are not turning, pull the brush ...

...from picking up water and cleaner. Clean or replace the filters if necessary. Check the suction path: The suction path could be blocked by dirt or debris. Check the suction path and clean it if ...

...The brushes are driven by air pressure passing through a small turbine. There is a filter in the path of the air flow. When it gets full of dirt it prohibits the air flow. You need to open the

Hoover Steam Vac ; The vac is not dispensing cleaner/water. I suspect the tubing/path from tank holding the cleaner/water mixture is clogged. Is there an easy way to unclogg it. Are there are sketches

...path so that you can leave the room without crossing the just cleaned floor. Pretreat any stains/heavily soiled areas with either the Bissel PreTreat formula following the directions for the product ...

...deep) and fastened with Phillips head. You will be able to see them with a flashlight. Take off the bag container door and remove the bag or dirt collection bin. There will be screws behind that as ...

...15. Additionally, check the Lint screen located on the tank lid. Liquid needs to have a clear flow path and a blocked screen will cause a suction to stop the flow. Hope that

...I hope you made sure the dirty water tank was empty and that the filter screen is