Questions & Answers for: past 20 days weather

...20-25 despite being set at 0. This happened last year but I honestly forgot about the problem until now. Any ideas?? Same problem as all of you. Mine happened at 17months old, not covered under ...

...past few weeks it has been hard to start when cold, the outside temp here has been below 20 degrees. I have to pump the foot feed or hold it to the floor to get the engine going, seems to be getting ...

...past 1.5 years. Each time I had driven a short distance(app. 2 miles) to the store, turned the van off for a short period of time, and when I tried to leave the engine wouldn't turn over. The starter ...

...past couple of days of cold weather. leak seems slight but leaving a trail over short distance driven since discovering possible fault about 20 metres! Bill Brown if it is yellow it could be the ...

...has ranged from 7 to 20 over the past two days. We have the pump and all the exposed lines wrapped in insulation. That sounds like a condensation problem somewhere along the power wire or at the

...20 minutes, and back. From that moment, until about 50K miles, Nano will constantly be working (even if you change tranny fluids), it will be on the entire internal (not in the lubricant), it will be ...

past 2-3 days.. I have since learned I do not have an igniter because my unit isn't gas? So I have researched further and now need a lil help as where I should go from this point.. The connector maybe

...past 3 days it went from gettin hot after awhile of driving it to driving it for 1 minute and its right under the H on the temp gauge How to Troubleshoot an Overheating Engine By Deanna Sclar from ...

20 posts - ?6 authors I could not start my Z this morning after not driving it for the past 4 days because of the weather. All lights come on the dash including the head lights but it won't crank. ...

...20 minutes it reads low almost near the red. before i replaced sending unit in mid acceleration it would go to 0 and the ecm would cut tyhe engine off. but it would start immediately after this ...