Questions & Answers for: HP OfficeJet paper rubber

...paper. Get yourself some "Rubber Renew" or similar product and a pack of cotton swabs. Open the panel in the back or remove the duplexer if that applies, and open the door in the front. Recondition ...

...and ensure that there isn't a small peice of paper lodged between them. I use a product called "rubber renew", it removes the dust, dirt, etc. and eats away someof the rubber to make it rough

...appplies downward pressure on the whole stack of paper. The rubber roller is on the right ,and a hard plastic one on the left. the rubber roller is the motorized feed roller. Clean both with a

...in the paper feed tray. Also check the paper pick-up mechanisms rubber roller for too much smoothness. If the rubber roller feels too smooth, Use a lint free cloth dipped in alcohol to "clean"

...paper tray, then more rubber rollers to pull the paper through the mechanism. If the printer is relatively new, the rubber rollers should be in good condition. As the printer ages, these get less ...

paper not getting inside 1. shuffle the paper before feeding in paper tray 2. clean the paper rubber roller inside the machine with detergent and water and wife it off with soft cloth/paper

rubber foot spin? does the paper get lifted? (or the foot lowered to the paper) If the paper is applied to the "foot" and the foot spins, and the foot can't grab the paper, it could just be a worn out

...paper path sensors occasionally. If you are not experiencing a jam every single print, you are probably in good shape. As for cleaning the rollers, if you have taken the rear door off the printer you ...

...noise like its going to pick up piece of paper but it does not grab/pick it up. You can try cleaning the rubber wheels with alcohol. Sometimes they become covered in dust and won't grab the

paper. They are assuming they are turning properly and the rubber grabbing wheels are wither dirty of dried out. In my case, however, the gears were not turning, and so the rubber grabbers wheels were