PT-45LC12 wont power up I have a pt-45lc12 that is about four years old. when I try to start it up, the green light will flash for about 10 seconds, then switch back to red without the picture coming ...
...Panasonic PT-45LC12 45IN REAR PROJECTION LCD TV. I noticed today a purplish color flicker on the left side of the screen. I am getting the same flicker on all inputs (componet 1, RGB, etc..) Is this ...
Question about PT-45LC12 45" Rear Projection HDTV-Ready Television
...PT-45LC12 has picture and fan problems My PT-45LC12 45 lcd screen shut off with the audio remaining on. I noticed at this point the fan was not running with no front panel fault lights, so I switched ...
Question about PT-45LC12 45" Rear Projection HDTV-Ready Television
Panasonic PT-45LC12 45" tv Hi, An angry bastard child hit my tv and broke the screen, does anyone knows where I can buy a replacenemt screen. A repair person?? A store?? something, someone, anything??
Question about PT-45LC12 45" Rear Projection HDTV-Ready Television
PT-45LC12 Problem after startup My rear projection tv is a bout 4 years old I just replaced the lamp ~5 months ago. I turn on the unit and get a good picture for ~ 30 sec then unit shuts off with no ...
Question about PT-45LC12 45" Rear Projection HDTV-Ready Television
...Panasonic PT-45LC12-K. Can you tell me how to turn off the "replace lamp" warning when the TV is turned on? I understand these directions are normally included with the replacement lamp. I purchased ...
Panasonic TV PT-61LCX65 Serial # - FSAA10347 June 2005 The TV power button turns green when I push it and it acts like it's going to turn on, but then it makes a weird sound a couple of times and it ...
Question about PT-45LC12 45" Rear Projection HDTV-Ready Television
...flashing power light and ticking noise but wont turn on I just replaced the lamp and the tv worked for a day...went to turn on again and the fans come on but no picture or sound. I can hear a ticking ...
Question about PT-50DL54 50" Rear Projection HDTV-Ready Television
...to reset the lamp for pt-45lc12 With power on, hold down VOL minus button on projection display and hold down the PIP or SPLIT button (try both) on the remote simultaneously for more than 5
Question about PT-45LC12 45" Rear Projection HDTV-Ready Television
...power light started flashing green. The temp light did not light up. If you take the back cover off (and part of the front) you should be able to the cage that holds the lamp. Above that there is a ...
Usually answered in minutes!
2,410 Questions
2,254 Questions
1,646 Questions
1,423 Questions
1,438 Questions