Questions & Answers for: panasonic microwave stays door open

...Clock is set by pushing "clock". entering time on number pad, and touching "clock" again. This should do it. My door doesn't open on my Panasonic, The Genius Prestige Microwave. ...

...panasonic NN-T664SFR microwave and the door button stays in when pressed. This means I can't shut the door. Is this something I can fix? Greg This is usually due to a grease buildup on the sides of ...

panasonic microwave, when unit is plugged in, unit is ok, when opening the door the RCD in the consumer box trips, close the door and reset the RCD power stays on try to run the microwave, and the RCD

...microwave (Panasonic) stays on even after you open door. Can it be fixed? The microwave running with the door open can be dangerous. It's most likely the switch in the door stuck in the closed ...

...stays on for approximately 1 minute, and continues to stop without beeps and no heating. Hi, Here is a tip that will help you to figure out what is wrong with yourMicrowave Oven.... Basic Microwave ...

...stays on and the indicator states the door is open. It is micro switch when you close the door, the door latch push in a button on the micro switch take lid off open and close the door and see if you ...

...Panasonic over the range microwave model # nnsd297s After the door was slammed a spark was seen coming from between the door and the control panel, The lights on the bottom stayed on for a couple of ...

...microwave. The unit ships with a protective film over the display that should be removed to make the display easier to read. However, this model is known to be difficult to read unless looking at ...

Panasonic 1250w microwave and the door won't close and latch and when it does the light stays on then once you do finally shut it and press start, the timer starts but microwave does not turn on! This

...Panasonic microwave Repaired latch inside door, but when I close the door the light stays on and reads close door How To Fix A Stuck Latch If your door can open correctly but can't close without ...