...know where I can find a logo for an N50 mixer? Looking for the "classic logo". I have a mixer I'm painting. Any suggestions on salvaging the one on the mixer? you would have to have it made not ...
what kind of paint should I use on my Hobart 20 quart mixer? Alot of people use house paint,but if you get a good primer and then an automobile spray paint such as 3m it works well.
Question about N50 Stand Mixer
...mixer has chips in the paint and the areas look rusty. I'd like to wire brush the spots and then prime and paint it. What kind of paint do I use that would be food grade paint? you can get spraycans ...
mixer. These screws are normally plainly visible - has it been repainted heavily enough to hide the screws? If you can't see the screws, all I can say is they are there, under the paint. Maybe shine a
...the other is how did you mix your paint , you cam trap air in the paint if you padle or stired it without a shaker mixer air will gas out of the paint, tofix this use a foam brush to flaten air ...
I want to take the stand and base off from the motor so I can have it sandblasted and painted. Is there a special offset tool or do I have to modify a screwdriver to seperate the two parts from my ...
Question about K5SS Heavy Duty Commercial Stand Mixer
paint of the mixer! Hello, I was given the KitchenAid K5SS Heavy Duty and I wanted to grease it. Frustratingly, after repeated hammering the groove pin will not come out of the shaft of the planetary.
paint mixer need belt size There are two different belts that have come on this machine, it depends on the year and the electrical rating. One is a round orange polyurethane belt, and the other is a v
Question about 5400 Heavy Duty Paint Mixer
is there a place that recoats mixer with proper food safe coating the paint is chipping off of my commercial mixer and I need to have it repainted is there someplace that does that
Question about 30 Qt Mixer Model D-300 Used Good Condition Original Paint
the mixer head on my D-300 has absolutly no power & turns very slow with a chattering like motion while on speed setting #3. I can also stop the mixer head from turning by hand. Motor or brushes to ...
Usually answered in minutes!
493 Questions
357 Questions
324 Questions
285 Questions
205 Questions