Questions & Answers for: Lexmark page 20

Ad

Question about E232 Laser Printer

5 Answers

...have any suggestions in terms of what I should do ??? Thanks ... Have the same problem after 1,500 pages! This was Lexmark's solution (and it worked)... Take the paperfeed tray out and you will see

Ad

20 more pages. Print the menu settings page(s) once more. Confirm that the photoconductor level is now at OK or close to 100%. If the photoconductor continues to give a low reading, repeat this entire

Ad

Question about E250dn Laser Printer

1 Answer

...page(s) for the Photoconductor AND the Toner. They show as OK when new (or very low count), and 100% when fully used. It IS ossible that the toner cartridge has a faulty (or if a remanufactured ...

Question about E238 Laser Printer

1 Answer

...20 pages. Print the menu settings page(s) again. Confirm that the photoconductor level reading is OK or close to 100%. If the photoconductor reading is still low, refer to the Configuration Settings ...

Question about E450dn Laser Printer

1 Answer

...a Lexmark e450dn Laser Printer and I had this problem with it for some time. After I print ~150 pages it jamms a paper inside it 2-3 times then this error message always apears: 935. after the

Question about E320 Laser Printer

1 Answer

...page setup shows the correct 20 inch size and it prints ok on an inkjet. Is there any way around this? is your printer a network printer? if it is open internet explorer type in http:// "your ip ...

...or close to 100%. If the reading is low, try printing 10 - 20 pages. Print the menu settings page(s) again. Confirm that the photoconductor level reading is OK or close to 100%. Good luck, Gerrit ...

Question about E120n Laser Printer

1 Answer

...page! Anybody know how to disable this? I have a C540n with the same problem. As well as the instructions, it prints a very large, very black arrow. I estimate that this uses the equivalent of about ...

Question about E238 Laser Printer

2 Answers

...20 pages. Print the menu settings page(s) again. Confirm that the photoconductor level reading is OK or close to 100%. If the photoconductor reading is still low, refer to the Configuration Settings ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Manuals & User Guides

Loading...