manual command settings in zebra 3301 need to be more especify ?!? to send commands to the printer, go to the driver. to calibrate send !SA command. To print card test send IM command. to reset senr R
hello zebra 330i not printing 1 mm on sde card Possible need printhead and ribbon calibration, please go to driver and send this command (!SA)
have problem wiht zebra p330i the ribbon ymcko printer that one good but the second printer star bad the ribbon is not synchronizes send !SA command from the driver to calibrate.
Question about P330i Thermal Card Printer
my zebra card printer p330 i donbt recognized the colour ribbo YCMK, only detect the mono ribbon from the driver send !SA command. to calibrate.
ribbon broken for zebra 330i printer please ajust the front plate (two screws) and run calibration (send from the driver, the command !SA)
zebra p330i prints half blank vertical on pvc card Printhead or ribbon sensor need calibration, please send the comand !SA from the driver.
I have an error message " mechanical error" what's the problem? Can be the sensors from the ribbon are not calibrate, Please sen the command "!SA" from the driver. If still do it, send to someone to ...
Question about P330i Thermal Card Printer
...zebra card printer p330 i donbt recognized the colour ribbo YCMK, only detect the mono ribbon The P330i is not supposed to work with the YMCK color ribbon, you should use the YMCKO 800015-440 color ...
...p330i printer? Colour calibration is always a bit hit and miss with these. You can get big variations between screen RGB and the YMC that is actually printed. Try zebra.com in the downloads you can ...
i have a zebra p330i id card printer my computer says that printer is insalled but wen i try to print any cards or even a test page the printer starts to warm up but doesnt print and after a while the
Usually answered in minutes!
2,817 Questions
2,244 Questions
2,162 Questions
2,149 Questions
1,912 Questions