...code P0344 I have a 2005 Pt Cruiser and the engine light came on the other day and it started to **** really bad when I accelerated. It does not happen all the time. It happened Thursday and then the ...
...p0344 i think it was, cam sensor circuit intermittant code. It was idling funny in park. I replaced the sensor and it ran great for about 2 hours. I went to the store and when i came out and tried to ...
Question about 2003 PT Cruiser
...PT cruiser P0440 and P0441 are refering to the NVLD pump. It is in the rear on the right side up near the fuel tank. P0344 is your cam position sensor on the rear (drivers side) of the cylinder head. ...
code P0340 & P0344 car was running then i turned it off to put my key back on chain and tried to start itr again and it wont start These codes indicate a possible camshaft position sensor failure,
...code po344 P0344 you have a failed camshaft sensor that is intermittent. There is a TSB that only the dealer can fix they will have to reflash the PCM number 18-15-09, this is the identification for ...
Question about 2005 PT Cruiser
...code P0344 CHRYSLER - Camshaft Position Sensor Intermittent Interruption Bank 1 Sensor 1Possible causes- Camshaft Position Sensor harness is open or shorted - Camshaft Position Sensor circuit poor ...
...I triedd to call up a code but coul not see one. P0344 is camshaft Position sensor,Dont get confused with the camshaft sensor, You have a timing problem and your solution is the timing
Question about 2006 PT Cruiser
...p0344-camshaft position sensor A bank 1 -circuit intermittent p0480- engine coolant blower motor 1- circuit malfunction p063a is not a valid fault code. To find the possible causes of the codes go to ...
P0344 on my 2007 pt cruiser. Already changed camshaft sensor (factory part) and had it diagnosed, they that there were no other issues and all wires were good. But I'm still getting check engine light
Question about 2006 PT Cruiser
...code says P0344 is that the camshaft position Sensor and is that all I need to do 2004 Chrysler PT Cruiser If it's just a bad sensor, then yeah. If there's a problem with the connector or wiring ...
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions