...optimum mixture throughout the rev range and the whole package is just working so much smoother and better - output at the wheel is now 72bhp. but...after all these mods shouldn't the bike be running ...
on channel one would mean antenna needs to be shorter and the opposite for channel one. A balanced reading or slightly lower reading in the midband channels would indicate antenna working near optimum
opposite of the power switch that looks like a circle with a **** in it. To set this to the optimum setting, plug the trimmers in and cut it on. Next, your going to use a flat head screwdriver to turn
Question about Grand WEGA KDF-55XS955 55" Rear Projection HDTV
...optimum point is toward the lower end of the brightness scale. But find the point that looks correct to you regardless of where it is on the scale. CONTRAST. The contrast control is similarly ...
Question about 73502 / 73504 / 73509 Bottom Freezer Refrigerator
...optimum flow of air over coils. I've been struggling trying to keep our 2 goldens dog hair from the coils of our 8 year old Kenmore side by side with "W" compressor coils, but like everyone else was ...
Question about 73502 / 73504 / 73509 Bottom Freezer Refrigerator
...opposite end from the needle). Release the tonearm, you have to turn the weights untill the arm is in balance, then turn 2 and a half so that the needle will go down (2.5 grams), this is the optimum ...
Question about 73502 / 73504 / 73509 Bottom Freezer Refrigerator
...optimum air fuel mixture you desire to make the engine run smoothly. Sometimes you must go the opposite, lever out and plate closed, depending on the way the carb is set up, and work it the opposite ...
Question about 1982 F 150
opposite direction (usually in) until the RPMs JUST start to drop off. That should be real close to the optimum setting. This setting is ONLY for the base idle air/fuel mixture and is NOT for anything
Question about 1998 Continental
...opposite directions so when you press it back in it seats tightly in the box space you will get the knack of it this will give a tight fit and improve all electrical distribution through the whole ...
...OPPOSITE OF WHAT U NEED TO DO? IF U TURN IT UP TO HIGH OR BOTH SETTINGS TO HIGH. U WILL GET A HARD WORKING STRESSED OUT COMPRESSOR, AND YOU WILL GET TO MUCH COLD IN ONE SECTION AND NOT ENOUGH IN THE ...
Usually answered in minutes!
652 Questions
681 Questions
595 Questions
586 Questions
644 Questions