Questions & Answers for: Empire Comfort Systems open valve

...open valve intermittantly the only way i can get valve to open every time is to jump with wire. I would be inclined to run new wire to stat if you are jumpering valve to get it to operate. However if ...

...Valve? If you tightened fully with a wrench, you over tightened it. Loosen the nut and take the fitting out, wait 2 minutes. Then, reinsert it, tighten it only finger tight and with the appropriately ...

cant start gas fireplace Find the remote's receiver under the fireplace.There should be a switch to change from "remote" to "ON".Turn the switch to "ON", if the fireplace ignites, you may need to re ...

empire wall furnace pushing down the pilot button trying to light the pilot found too much gas flowing Is the button on the gas valve or a red button in the line to the pilot assembly? If its in the ...

...later and it would not light The pilot is dirty. You need to take the pilot assembly apart and clean the orfice and hood. Make sure to spray for leaks after the gas valve is in the open

...working Have you checked for 12V at the bulb holders themselves? If 12V present, bulbs are bad or open ground at the light socket. Does it have power at the fuse? If not there is a broken wire try ...

...vent control. fan limit switch ohm is 50, other two ohm is 0 to .03 All fan switches should read open line or "OL" when the furnace is cool, but if the motor seems stiff see if it is oilable. It ...

Replaced thermocouple pilot stays on but burner wont light Make sure the gas valve dial is turn to the "on" position. Otherwise, I would need more info to answer this question fully.