Questions & Answers for: oil pump husqvarna

oil pump drive gear was stripped and had to be replace. It's located under the flywheel/sprocket so you have to pull that. I couldn't find info on how to do that so had a local shop repair it for $70!

oil pump on my Husqvarna chain saw is not pumping as much oil as I think it should. I took off the bar and started the motor and it is pumping but I get through only a quarter (or less) of an oil tank

oil pump with inlet line full of oil and ran pump with coreless drill in both directions and no oil flow checked inlet and outlet on pump lined up with hoses still no pumping. How do these pumps work

...oil replaced oil pump and worm gear and still little or no oil to chain. whats left? Check the oil lines to make sure none of them are clogged and that the oil holes in the bar aren't

...oil pump, the adjuster is a black plastic screw located to the top right hand corner of the pump face, just behind the sprocket, you will have to clean around that area to find it. The pump has ...

oil tank it pours out around the pump. Am i correct in thinking this isn't a pump problem but maybe a hose leak from the oil tank or breather port. If so how do i access these!? Please help; i

...on the model the pump is often linked to the oil line via a little gromet. Check these parts all link up correctly and nothing has got damaged.The picture shows the oil pump assembly on a Husqvarna ...

...oil pump on Husqvarna 257 How to replace the oil pump for the chain The oil pump is behind the clutch. You will see 3 bolts holding the pump in place. Some pumps must use the M5 screws in the 180 ...

...oil pump is fixed and driven by a gear behind the sprocket, on the bottom of the crankcase is a large alloy screw with a slot in it, behind here is a filter for the chain oil, this should be cleaned ...

...not oiling? I cleaned the holes in the bar and replace a new oil pump. How do I fix this problem? Hi Joe videos that may help. https://www.google.com/search?q=Husqvarna+51+chainsaw+not+oiling