Question about 1993 Grand Cherokee
oil pressure goes from around 25 at idle and almost 50 sometimes engine idles a little low aroun 800 rpms. I flushed engine with gunk and presure is the same. there could be several reasons for this ...
Question about 1988 Cargo
...oil pressure gauge reads maximum all the time. I have a 1984 motorhome that is on a Chevrolet P30 chassis with a 454 chevy engine. The oil pressure gauge has pegged all the way to the high end. It ...
...oil pressure switch . I check the pressure with a gauge it goes to 50 when i start it the engine is very quiet but that light drive me crazy please help me. Its a honda accord 1993 the oil pressure ...
Question about 1994 Grand Cherokee
oil pressure sending unit on a 1993 jeep grand where is the oil pressure sending unit on a 1993 jeep grand cherokee on the 4.0 motor Under hood, passenger side, lower engine area, rear of distributor,
...oil pressure sending unit, i've replaced the unit but now the low oil warning buzzer is going off (didn't previously do this) and warning light stays (also not a previous problem) on when engine is ...
...oil pressure, that is. Connect a gauge where the oil pressure sending unit usually goes after unscrewing the sending unit, and measure the pressure to see if it within specifications. If below, then ...
...oil pressure sending unit, or the engine could really have no oil pressure. If the oil pressure dropped to zero at highway speed, I would expect the engine to lock up or at least make alot of noise. ...
Question about 2002 LeSabre
oil pressure sending unit 3/8 deep socket remove oil pressure sending unit you need teflon tap sealer for oil sending unit threads.okay to replace oil pressure sending unit.you need safe raise support
...oil pressure went to 0 psi recently replaced oil,filter, and pressure sending unit (the old unir was leaking) A leaking filter and oil pressure switch would cause the lack of oil pressure. Does the ...
Oil pressure sending unit. have a 1991 chevy c3500 with the 454 just replaced the oil pressure sending unit by the balancer area and it still reads 0 has oil and no clatter in the engine, Is there ...
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions