Questions & Answers for: oil ingersol rand 2475

...rand type-30,model#2475 7.5 hp,3 phase.need a wire diagram or how do you wire up the low oil and pressure switch? this is a used compressor with wiring still conected, has 3 leads to the contacts (8 ...

...2475 ir (5hp) has no dip stick or oil level glass;only oil cap.how much oil is needed for proper level? In the owners information your compressor takes the 1 bottle of IR oil that comes with it. If ...

my 2475 will not start up, I can override that by pushing the button on the Contactor Does this unit have a low oil level switch? If so make sure it's full of oil. If not you have a bad starter coil.

...oil does the 2475 hold A 2475 has no way to tell how much oil is in it other than removing the oil fill plug and looking unless a low oil level switch has been installed. You should fill this unit to ...

...Rand type 2475 - The piston has seized on the crank - how do we remove if it is seized the connecting rod to the crank u will probly have to cut it with a torch or grinder. be carful not to start a ...

...2475 unit I would look at the pressure switch. If you are saying the unit starts/stops/starts etc and it is equiped with a low oil level switch the oil level is low. fill it to the oil fill plug ...

Rand "Select" oil is a synthetic oil recommended by Ingersoll as better than mineral oil. T30 (mdl 2475) and T21 are different styles of compressors. So, yes "select" oil can be used in the Model 2475

Rand air ... An air-cooled aftercooler, low oil level ... for Models 2340, 2475, 2545, 7100, 15T & 3000 ... Ifcooling of the discharge air is required, .... motor does not have this button and the