Questions & Answers for: oil gauge stuck zero

...oil light, battery light, abs light, both check engine and service dash light comes on. gas gauge stuck wont move from zero or whatever. its happened before, twice. first time it sat for a week, then ...

...gauge I replaced my oil presure sensor and my gauge sits way past 80 and does not react.I bought a new sensor from the dealership this time and realized that the old one had two prongs on the ...

...gauge to the engine and read actual oil pressure (attaches right where sender screws in). That will tell you if the problem is inside the engine or in the gauge system. If it turns out to be inside ...

...oil gauge go to bad, the oil pressure sending unit may have gone bad, the oil pump may have quit. I suggest you find the oil pressure line coming off engine, put another oil pressure gauge on it and ...

Oil gauge is stuck all the on high, after starting the engine Sound like a posible bad oil pressure sending unit . It is normal for pressure to be above normal just after starting . At a cold idle , ...

...oil changes. Mechanical gauge reads about 40 psi at idle when cold, 15 when warm. While shifting into reverse it drops to about 11, and drive drops to 13psi. The levels seem alright, but the gauge ...

gauge reading (or oil warning light) would indicate a serious internal engine problem that is preventing normal oil pressure from reaching the upper valvetrain components. The cause might be a worn or

...gauge. It may be stuck or otherwise not working. If you have fuel, check your fuel filter. It may be clogged. If your fuel filter is good, you may have water contamination. Drain your tank and refill ...

...oil pressure gauge went to zero back 1 month ago, we changed the oil sending unit, no change. Any ideas on what next? You need to get an actual pressure test on the block to get an actual reading, ...

...oil but compression is #4 135 psi and 1, 2, and 3 all zero. I cannot imagine what might cause this scenario. Any suggestions, ideas of problem cause and fix would be greatly appreciated. Thx in ...