Questions & Answers for: oil cooler pressure

...oil cooler had failed. Its an expensive fix. But less costly than a blown head gasket. Your head gasket it shot, replace it. Possible blown head gasket(s) and/or warped head(s). There may be water in ...

...oil. Oil cooler checks out. took the head off and gasket looks good. Blew air into oil-ports on head, there was pressure. you have either a cracked head or a cracked block, there is no other way to ...

...oil pressure line and trans cooler line (as described by Mieneke). However, I cannot find any info online about the two lines. Are they called something else? How do I find them on my truck? ur trans ...

oil cooler. The oil cooler has broke mixing the gearbox oil and coolant causing this milkshake. It's a small radiator core type oil / water heat exchanger. It is cracked inside and transmission oil is

...oil cooler failed. If brown engine oil cooler failed, oil pressure is higher than coolant pressure. Check the oil cooler for corrosion internally, problem is common. Possible head gasket failed or ...

...oil cooler lines to the motor for it to make the oil pass through the cooler Most oil coolers attach between the spin on oil filter and the engine. Usually a special plate the oil lines bolt to is ...

...oil cooler issue. Does this engine have an oil cooler and could this be the problem? The oil cooler is almost definatly the problem The reason for this is. Your oil pressure is normaly anywhere ...

...oil cooler and has coolant passing around it in a jacket. The oil pressure is greater than that of the cooling system pressure. Replace that cooler and flush the cooling system. This should cure it. ...

...oil cooler or could the cooler be bad......need help in alabama Assuming the crankcase is full of oil, I doubt the cooler would cause a drop in pressure. Only a small percentage of oil flows thru the ...

...oil cooler pressure control valve on a chrysler 1999 300m do? if it it is a pressure control valve it would be I assume a way to slow the oil down enough so that heat would be removed from the oil ...