NorthStar generator. Motor purrs right along but when I hook up any power equipment there is almost no power. There is enough power to start a table saw but it doesnt get enough wattage to cut through
...Generator runs great, but not putting out voltage. If you have checked the stator, rotor and brushes and they appear alright then it is probably a voltage regulator. The honda dealer can run a test ...
Question about Generator 20 Hp, 13,000 Watt, Trifuel
northstar generator w/GX620 engine shutting down my generator model#10500SBG will not run anymore,although it ran fine for 2+ years. Natural gas version,I have 7" water column pressure at regulator. ...
What is a avr card? where is it? I don't where it is on yours but an AVR is a voltage regulator so it will be somewhere in between the ac generator and the inverter.
Question about Generator 9 Hp, 5500 Watt, Gasoline
NorthStar 5500W generator The stator is the series of copper windings inside the generator (does not move,). The stator will have several pairs of leads connected to the control panel. The rotor
Question about 13000/10500 Watt Electric Start CARB Compliant Generator
Voltage is too low to kick on house electric. How to increase voltage from 208 to 240? if the engine is running at the proper rpm's replace the voltage regulator
Question about Generator 9 Hp, 5500 Watt, Gasoline
my north star 5500 generator starts but does not put out any electricity through the plugs Check the connections between the alternator (generator) and the regulator/output connectors.
Question about Generator 9 Hp, 5500 Watt, Gasoline
northstar generator that runs but not putting out any power have not tried anything yet If it has sat, it may have lost it's rotor residual magnetism. Disconnect the rotor field wires at the AVR or on
Question about Generator 9 Hp, 5500 Watt, Gasoline
A Northstar generator, 10,500 watt. What controls the output voltage a voltage regulator that controls the field winding voltages
Question about Generator 9 Hp, 5500 Watt, Gasoline
...northstar 2400 generator, output voltage is half of what it should be. parts do not show brushes so any idea where brushes would be If there are no brushes in the parts list then it is brushless. It ...
Usually answered in minutes!
627 Questions
549 Questions
535 Questions
166 Questions
208 Questions