Questions & Answers for: nokia 6300 front cover

...from the Nokia 3110c cell phone? I want to change my camera glasses it is best to take it to a mobile shop and have them remove it for you i want to remove the front cover to change it show me ...

nokia 6300 mic problem hey, did you ever fix your nokia 6300 microphone problem? mine quit on me recently after changing the housing. Hi, I too changed the front cover, middle section and battery ...

...nokia 6300 full housing ive managed to get the front and back cover off and put the hardware (screen thingy) into my new housing and i tried putting the charger in the bottom of the phone in but im ...

...front cover is getting loose can that be fixed as well? Everything is possible at least in India mic change cover change don't know about the place you live in but the mic on a 6300 is similar to the ...

...nokia 6300 and have now noticed that the camera does not work. It says operation failed when you open the camera open up your phone again and try to aplly slight pressure on the moard across the ...

...nokia 6300 in detail Does anyone have a manual on how to disassemble this phone? I also need to change the front fascia, which I think involves removing the back plate and I can;t see how this comes ...

...6300 is this possible Yes why not you can buy it from any mobile repairing shop. Thanks Yes, it is just get a new case for your phone and follow the instructions below. Hey i found an article on how ...

...nokia 6300 just changed. the dispay writing is now upside down and in reverse. what is the prob and how do i get it back. i have tried restoring factory settings but no success. Hi, You mean that it ...

...front housing or cover * unscrew 4 screw on all corner of lcd frame * Lift up the entire module ( board & LCD ) start from the top * Now you see the charging pin at the bottom,lift it up. Good ...

front cover, lift the rubber keypad and clean the button surface with damp cloth. NOT WET. Allow it to dry for a few minutes, reassemble and start using. Some dust may have gone between the rubber pad