Questions & Answers for: noise turning key position

key to the off position. What could be making this noise? If you have a tape cassette player in the dash, this can cause a sound like what you are describing. Even though a tape is not in it,,, it can

noise is still there!!! Your fuel pump is supposed to hum, when you turn the key it primes the system and it will hum. When the car is running the fuel pump is running and it will hum. If the noise is

...of hitting the MI Button . 4/ Press the MI Button and turn the key into the # 2 position at the same time. There will be a confirmation noise . 5/ Release, Smile...and be on your way, your all done.

key if theres no noise, its probably the starter. but the best way to check is turn the key to "on" position and "jump" the solenoid terminals. The solenoid should be on the fenderwell somewhere, just

key to the run position. The noise is intermittent an sometimes occurs during idle and continues after the car's engine is shut off. It continues while the key is in the run position until the

...key, has battery power, no noise at all from the engine. Belt is fine, alternator is fine. When key is turned to on position, no noise, no clicking or anything. Lights all work, guages look fine. ...

...noise comes when key is turned -Turn key, strong lights, engine turns over but will not fire. A tractor is a complex piece of machinery and something like an engine that will not start could indicate ...

...noise continued even when the key was not in ignition only stopped when removed the old battery. Now that the new battery is in the clicking only happens when the key is turned to accessory position. ...

...key out i still here the clicking noise. Access the ignition switch, remove the connector, and test the switch using an ohmmeter. Procedures for accessing the switch are available at the link below. ...

...turning the key to the start position and then getting a clicking noise most likely it is your starter solenoid. If the key is just in the on position or what we call run position it is likely some ...